Cyclades AlterPath OnBoard Informacje Techniczne Pobierz pdf (Strona 174)

100

101

Configuring Private Subnets and Virtual Addresses—Wizard

134 AlterPath OnBoard Administrator’s Guide

4. Click the “Edit” button for the entry for the private subnet you want to

change.

5. Accept or change the name of the private subnet in the “Private subnet

name” field.

6. Accept or change the IP address in the “Onboard side IP address” field.

7. Accept or change the netmask for the subnet in the “Subnet netmask”

field.

8. Click OK.

9. Click “Save and apply changes.”

10. Click the “Next” button, if desired, to go to the next Wizard step.

Configuring a Virtual Network

A virtual network based on Destination Network Address Translation (DNAT)

must be defined in the following cases:

• When multiple subnets must be supported (as when connected devices are

previously configured with IP addresses from multiple address ranges,

and it is not feasible to change the already-defined device IP addresses

and the administrator does not what users to be required to set up a

separate route to each subnet from their workstations)

• When it is important to hide the addresses of connected devices from

users by the use of virtual IP addresses

Figure 4-16 shows the fields for configuring a virtual network with DNAT,

which appear on the “Configure Subnets” Wizard screen.

Figure 4-19:“Configure Subnets” Screen: Virtual Network (DNAT)

Configuration

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 501 502

Komentarze do niniejszej Instrukcji

Brak uwag

Cyclades AlterPath OnBoard Informacje Techniczne Strona 174

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Cyclades AlterPath OnBoard