Cyclades AlterPath BladeManager Instrukcja Obsługi Pobierz pdf (Strona 105)

Chapter 5: Using the Web Manager 91

Configuring SNMP trap notifications

If the Simple Network Management Protocol (SNMP) service is enabled on the SP manager, the

administrative user can use the SNMP Trap Add dialog to send notifications about significant

events to an SNMP management application, such as HP Openview, Novell NMS, IBM NetView

or Sun Net Manager.

The SNMP Trap Add dialog may be used for configuring an alarm trigger and a SNMP trap

notification to be sent if the specified alarm trigger occurs.

To configure SNMP trap notifications:

1. Select the Config

- Notifications menu option.

2. Select SNMP trap from the pull

-down menu.

3. Select Add.

4. Check or leave unchecked the checkbox next to Scan target device console session

for matches.

5. Enter a name for the trigger in the Name field.

6. Use syslog

-ng syntax to specify an event to trigger the alarm in the Alarm trigger field.

7. Select a protocol from the Protocol menu.

8. Enter an OID in the OID field.

9. Select one of the trap designators from the Generic trap type pull

-down menu. If the

enterpriseSpecific trap designator is selected, you are prompted for a specific trap number.

10. If either SNMP v1 or v2c is selected, enter a community name in the Community field.

11. If SNMP v3 is selected, perform the following steps:

a. Enter a username in the User field.

b. Select an authentication level from the Auth Level pull

-down menu.

c. If Auth or Auth & crypt are selected, select an option from the Auth Level menu.

d. Enter an optional password in the Auth password field.

e. If Auth & crypt is selected, select an option from the Encryption menu.

f. Enter an optional password in the Crypt password field.

12. Enter an SNMP server IP address or DNS name in the SNMP server field.

13. Enter any desired text in the Body field.

14. Click OK.

15. Click Save and apply changes.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 239 240

Brak uwag

Cyclades AlterPath BladeManager Instrukcja Obsługi Strona 105