Cyclades AlterPath BladeManager Instrukcja Obsługi Pobierz pdf (Strona 78)

64 MergePoint 5224/5240 Service Processor Manager Installer and Administrator Guide

Subnets and Virtual DNAT Networks on the MergePoint 5224/5240 SP Manager on page 50 and in

more detail in Target Device Configuration on page 169.

At least one subnet is needed to enable devices that are connected to the SP manager’s private

Ethernet ports to communicate on the Internet via the SP manager’s public IP address. Any number

of private subnets may be configured. Configuration of one or more virtual networks is optional.

Subnets are defined using the values described in Table 4.17 on page 51.

Virtual networks are defined using the values described in Table 4.18 on page 52.

CAUTION: Changing or deleting an existing private subnet changes the configuration of any device that was

previously configured to use that private subnet; the private subnet is removed from the device’s configuration,

and on subsequent attempts to contact the device, the SP manager tries to use the default route. If changing or

deleting a private subnet, make sure to reassign all affected devices to another private subnet to avoid making

devices unavailable.

To add a private subnet (Wizard):

1. Click the Wizard button.

2. Select the Subnets option in the left menu bar.

3. Click the Add Subnet button.

4. Enter a meaningful name for the private subnet in the Private subnet name field.

5. Enter an IP address within the private subnet’s network address range in the Appliance side IP

address field.

6. Enter a netmask for the subnet in the Subnet netmask field.

7. Click OK.

8. Click Save and apply changes.

9. Click the Next button, if desired, to go to the next Wizard step.

To edit a private subnet (Wizard):

1. Click the Wizard button.

2. Select the Subnets option in the left menu bar.

3. Click the Edit button for the entry for the private subnet you want to change.

4. Accept or change the name of the private subnet in the Private subnet name field.

5. Accept or change the IP address in the Appliance side IP address field.

6. Accept or change the netmask for the subnet in the Subnet netmask field.

7. Click OK.

8. Click Save and apply changes.

9. Click Next, if desired, to go to the next Wizard screen.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 239 240

Brak uwag

Cyclades AlterPath BladeManager Instrukcja Obsługi Strona 78