Cyclades AlterPath BladeManager Instrukcja Obsługi Pobierz pdf (Strona 28)

14 MergePoint 5224/5240 Service Processor Manager Installer and Administrator Guide

To configure basic network parameters using a terminal:

1. Using either a terminal or a terminal emulation program installed on a computer that is

connected to the SP manager, start a session with the following console port settings: Serial

Speed: 9600 bps, Parity: None, Flow Control: None, Data Length: 8 bits, Stop Bits: 1 and

ANSI emulation.

2. Log into the console port as the root user with the default password

cyclades.

CAUTION: For security, change the default password for the root user immediately.

3. Enter the passwd command, and enter and confirm a new password when prompted.

[root@MergePoint5224 /]# passwd

4. Invoke the cli utility.

[root@MergePoint5224 /]# cli

5. Make sure the primary Ethernet interface (eth0) is active, then set the method to static, assign a

static IP address, a gateway and a netmask.

cli> set network interface eth0 active yes method static address

SPmanager_IPaddress gateway gateway_IP_address netmask netmask

6. Specify a hostname, a domain, a DNS server IP address, and an optional secondary DNS

server IP address.

cli> set network hostname SP manager_name resolv domain domain_name

dns0 DNS_server_IPaddress dns1 secondary_DNS_server_IPaddress

7. Confirm the configuration for the interface.

cli> get network interface eth0

8. Confirm the name server configuration.

cli> get network resolv

9. Save the changes.

cli> commit

10. Exit from the cli utility.

cli> quit

11. Log out and enter the IP address in a browser to bring up the Web Manager to add users and

configure access to target devices as desired.

12. Finish configuring security, users and target devices on the SP manager using the Web

Manager.

To use a dynamic IP address to access the Web Manager:

This procedure assumes that DHCP is enabled and that you know the IP address that is currently

assigned to the SP manager from a DHCP server on the same subnet.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 239 240

Brak uwag

Cyclades AlterPath BladeManager Instrukcja Obsługi Strona 28